The ADSS OCSP Monitor Service Manager module allows authorised operators to start or stop OCSP Monitor and to make changes to service related configurations.

The OCSP Monitor Service Manager screen is shown below:

The configuration items are as follows:

Items

Description

Service Address

The address of the OCSP Monitor service being controlled from this Service Manager. Ensure the address points to the correct service URL, i.e. if you are running the service on multiple machines in a load-balanced configuration then check that the name is correct for the particular instance that needs to be started/stopped/restarted. By default it will be that of the local machine.

Start

Start the service. Status will change to “Running” after a successful start.

Stop

Stop the service. Status will change to “Stopped” after the service is stopped.

Restart

Stop and then start the service in one go, Status will change to “Running” after a successful restart.

Scenario Reports Location Reports File Path 

This defines the path to the location where Scenario Reports will be stored.

Daily Summary Report Settings

This allows you to define the time at which Daily Summary Report is created.

Note:

  1. The widget shows A.M. and P.M. times on separate tabs.
  2. Report Creation Time should not be configured as 12:00 AM as it is the starting time of the current date. It will conflict with time configured as Stop time inside Test Scenarios because Scenario's Stop Time should be less than Daily Summary Report Creation Time. It is recommended to use 11:59 PM

    You can select (and deselect) the system operators to whom report is sent. Operators are defined in the Access Control module.


Ensure all the changes are saved by clicking the Save button and restart the service to take changes effect.

See also

Test Cases
Test Scenarios
Live Report
Transactions Log Viewer
Logs Archiving
Alerts
Management Reporting