Home > Operational Management > Starting & Stopping ADSS Server

Starting & Stopping ADSS Server

This section describes how to start / stop ADSS Server. It is assumed that you have already successfully installed ADSS Server as described in the installation guide.

Windows OS

ADSS Server can be started/stopped in two ways on Windows operating systems:

• Launch the Windows Services Panel and start the services named Ascertia-ADSS-Core, Ascertia-ADSS-Console and Ascertia-ADSS-Service. This is the recommend approach to start the ADSS Server. Stop and Restart options are also available.
  
• ADSS Server can also be started using the batch files. Go to [ADSS Server Home]/tomcat/bin directory and run the following bat files:
  • startup_core.bat
  • startup_console.bat
  • startup_service.bat
    
    If ADSS Server is started using the batch files then these be stopped by executing the following batch files:
  • shutdown_core.bat
  • shutdown_console.bat
  • shutdown_service.bat
    
    This is not the recommended approach unless support asks you to do this.

ADSS Server can be started/stopped in two ways on UNIX based operating system:

• The ADSS Server can be started from the tomcat daemon. The following are the commands:
  • /etc/init.d/tomcatd-ADSS-core start
  • /etc/init.d/tomcatd-ADSS-console start
  • /etc/init.d/tomcatd-ADSS-service start
    The other supported options are stop, restart and status
• ADSS Server can also be started using the batch files. Go to [ADSS Server Home]/tomcat/bin directory and run the following bat files:
  • startup_core.sh
  • startup_console.sh
  • startup_service.sh
    
    If ADSS Server is started using the shch files then these be stopped by executing the following shch files:
  • shutdown_core.sh
  • shutdown_console.sh
  • shutdown_service.sh
    This is not the recommended approach unless support asks you to do this.

See also