ADSS operators can control ADSS services and configurations for a specific server. This can be done by clicking on any server name whose status is shown as connected and the following GUI will be displayed showing the status of each ADSS service running on that server.

From here any specific service can be started/stopped/restarted or the operator can restart all services in one go using the Restart button. IP Address/Host Name can be changed using "Edit" button and to remove an instance"Delete" button can be used.

Also, in the above image, global configurations, trust manager settings, archiving settings, alerts settings, HMAC settings etc. can be reloaded in one go by clicking on “Restart System” button. Any changes made in the relevant ADSS Server instance will be effective after configurations are re-loaded successfully.

​If you have changed the host name/IP for any of the machine where ADSS Server is deployed then you may also need to change this information in the ADSS Server to make it work normally. The machine whose host name/IP has changed will be shown with status "Not Connected" and "Edit" and "Delete" options will be available. Click the "Edit" link to set the ADSS Server name according to the new host name/IP for the ADSS Server. You can either remove a machine (for which host name/IP is changed) by clicking the "Delete" button if you wish to remove it from the load-balanced configuration.



See also

ADSS Services
System Health